Page 1 of 1

'End call' from Yealink handset not recognised by phone ameg

PostPosted: Mon Apr 18, 2016 8:59 pm
by zzzland0
Today I upgraded from the trial version of Phone Amego to the paid version. But now if I end a call from my Yealink handset, the Phone Amego call window is still active and shows that the call is still active. The call screen only goes away when I click end call on screen. This was never a problem until I upgraded.

Any assistance is greatly appreciated.

Re: 'End call' from Yealink handset not recognised by phone

PostPosted: Mon Apr 18, 2016 9:23 pm
by zzzland0
I have also noticed that when an incoming call comes in that the phone amego call screen is no longer appearing for that call, it is only appearing for dialled calls from phone amego.

Re: 'End call' from Yealink handset not recognised by phone

PostPosted: Sun May 15, 2016 9:43 pm
by psichel_adm
Phone Amego has a Debug Log you can enable under the More tab. Can you review the Debug Log to see what URL your phone is sending to Phone Amego to signal Call End? Is it the same as the one shown in the PA User's Guide?